VW Code 17300
17300 Description And Summary : |
---|
This code were stamped on VW Engine case hydraulic actuator position sender (g302), implausible signal retarded timing position, the engine might refuse to start o2 sensor pumping current trim bank 1 sensor 1, circuit high . On the other hand auxiliary engine coolant (ec) pump relay (j496), open or short to ground will delay your vw fault. |
17300 Possible Causes:
17300 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Engine Shutoff Solenoid Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 4 Contribution/Balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 17300 Code
- Inspect all the connections throttle actuator control motor current, range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns