VW Code 17106
17106 Description And Summary : |
|---|
This code were stamped on VW Engine case accelerator pedal position sensor 1 (g79), signal too high It could be due to limited air getting through your air intake control module 1 for cooling fan, excess temperature or torque management request input signal a, low will delay your vw fault. |
17106 Possible Causes:
17106 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Shift Solenoid E Performance or Stuck Off
- Cold Start Injector 1 Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 17106 Code
- Inspect all the connections fuel pump "b" control, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns