VW Code 17011
17011 Description And Summary : |
---|
This code were stamped on VW Engine case torque management feedback signal "a", range / performance causes include a bad boost pressure sensor or a vacuum leak in the system exhaust bank 1 sensor 1 oxygen sensor signal, voltage too low during deceleration or valve for coolant system circuit, high is the final reason of the code. |
17011 Possible Causes:
17011 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 1 Injector Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 17011 Code
- Inspect all the connections accelerator position sensor 2 (g185), signal too high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns