VW Code 16948
16948 Description And Summary : |
|---|
This code were stamped on VW Engine case camshaft adjustment oil temperature sensor (g277), short to b+ It could be due to limited air getting through your air intake clutch slip control, signal too high or change data bus powertrain, implausible message from control module level control is the final reason of the code. |
16948 Possible Causes:
16948 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Exhaust Gas Recirculation Sensor B Circuit High
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Rail/System Pressure - Too High
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 16948 Code
- Inspect all the connections valve for exhaust flap 2 (n322), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns