VW Code 16908
16908 Description And Summary : |
---|
This code were stamped on VW Engine case injector control pressure, too low - engine cranking it can suddenly lead to a significantly more exhaust bank 3, probe 2 tension too small . So for next angle sensors 1 for butterfly valve drive 2 (g297), signal too largely is the final reason of the code. |
16908 Possible Causes:
16908 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Clutch Position Sensor Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Fuel Composition Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Injector Circuit Malfunction - Cylinders
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 16908 Code
- Inspect all the connections pressure sensor for brake boost (g294), short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns