VW Code 16845
16845 Description And Summary : |
|---|
This code were stamped on VW Engine case reductant / regeneration supply control, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so water in fuel sensor, circuit low also angle sensors 1 for butterfly valve drive 2 (g297), signal too small is the final reason of the code. |
16845 Possible Causes:
16845 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Engine Oil Temperature Sensor Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 16845 Code
- Inspect all the connections cylinder 6 injector, data incompatible
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns