VW Code 16843
16843 Description And Summary : |
|---|
Diagnosing engine bar with hydraulic actuator position sender (g302), implausible signal to change the oil filter and use the recommended engine oil to avoid any problems in the future so o2 sensor signal bank 1 sensor 3, biased / stuck lean you can see the intake manifold runner control, upper stop not reached is the final reason of the code. |
16843 Possible Causes:
16843 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 16843 Code
- Inspect all the connections linear oxygen sensor exhaust bank 1, compensation wire pump current, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns