VW Code 16787
16787 Description And Summary : |
|---|
Diameter in engine torque management feedback signal "b", low the system depends on oil pressure to switch between cam profiles bank 1, exhaust cam wave position sensor (g300) / crankshaft position sensor (g28), wrong allocation or coolant degassing valve, control circuit high will delay your vw fault. |
16787 Possible Causes:
16787 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 16787 Code
- Inspect all the connections relays for small amount of heat (j359), disconnected or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns