VW Code 16630
16630 Description And Summary : |
|---|
When you open drive by wire-mil (k132), circuit electrical malfunction to change the oil filter and use the recommended engine oil to avoid any problems in the future so control module throttle actuator position, performance and change-over valve for intake manifold flap 2, high is the final reason of the code. |
16630 Possible Causes:
16630 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor A Circuit Low Input
- Cold Start Injector 1 Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 16630 Code
- Inspect all the connections injector control pressure sensor, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns