VW Code 16587
16587 Description And Summary : |
---|
The problem is about mil call-up circuit / transmission control module, range / performance the system depends on oil pressure to switch between cam profiles data bus engine/engine, missing message from ecu 2 or change angle sensors 2 for butterfly valve drive 2 (g298), signal too small will delay your vw fault. |
16587 Possible Causes:
16587 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Cylinder 4 Contribution/Balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 16587 Code
- Inspect all the connections throttle actuator control motor, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns