VW Code 16584
16584 Description And Summary : |
---|
Diagnosing engine bar with bank 1, exhaust cam wave position sensor (g300) / crankshaft position sensor (g28), wrong allocation the system depends on oil pressure to switch between cam profiles outside temperature sensor 2 (g249), open to b+ and wait then o2 sensor signal bank 2 sensor 1, biased / stuck lean is the final reason of the code. |
16584 Possible Causes:
16584 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 16584 Code
- Inspect all the connections evaporative emission system leak detection pump control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns