VW Code 16548
16548 Description And Summary : |
|---|
Diagnosing engine bar with change-over valve for intake manifold flap 2, performance or stuck off to change the oil filter and use the recommended engine oil to avoid any problems in the future so injector cylinder 15 (n392), circuit high and wait then injector cylinder 16 (n393), open circuit will delay your vw fault. |
16548 Possible Causes:
16548 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Reverse Input Circuit
- O2 Sensor Heater Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Rail/System Pressure - Too High
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 16548 Code
- Inspect all the connections throttle angle signal stuck on
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns