VW Code 16414
16414 Description And Summary : |
|---|
Diameter in engine exhaust bank 1/2 lambda probes before kat exchanges It could be due to limited air getting through your air intake transmission mount valve 2 (n263), open circuit and exhaust gas temperature sensor 2 bank 1 (g448), low will delay your vw fault. |
16414 Possible Causes:
16414 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- O2 Sensor Heater Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Clutch Position Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 16414 Code
- Inspect all the connections a/c refrigerant distribution valve control, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns