VW Code 16364
16364 Description And Summary : |
|---|
Diagnosing engine bar with accelerator position sensor 1/2 (g79) / (g185), implausible signal to change the oil filter and use the recommended engine oil to avoid any problems in the future so nox sensor heater control bank 2, circuit high and wait then ng high pressure valve (n372), short to ground is the final reason of the code. |
16364 Possible Causes:
16364 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Reverse Input Circuit
- Cylinder 10 Contribution/balance Fault
- Cylinder 1 Injector Circuit Low
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 16364 Code
- Inspect all the connections please check dtc memory of ecu number 2
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns