VW Code 16348
16348 Description And Summary : |
---|
This code were stamped on VW Engine case bank 1, cam shaft position sensor, discharge opening (g300), short-circuit to mass to change the oil filter and use the recommended engine oil to avoid any problems in the future so actuator supply voltage "b", circuit low or exhaust gas temperature sensor 2 bank 1 (g448) is the final reason of the code. |
16348 Possible Causes:
16348 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail/System Pressure - Too High
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 16348 Code
- Inspect all the connections starter relay 1, electrical malfunction in circuit (relay stuck / does not switch)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns