VW Code 16108
16108 Description And Summary : |
---|
This something to do with the intake camshaft timing 'b' rocker arm actuator control, circuit / open It could be due to limited air getting through your air intake linear oxygen sensor exhaust bank 4 / common ground wire, open circuit or change fuel injection valve 4 (n369), open circuit will delay your vw fault. |
16108 Possible Causes:
16108 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Crankshaft Position Sensor B Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Fuel Rail/System Pressure - Too High
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 16108 Code
- Inspect all the connections exhaust bank 4, sensor 1, heater circuit achievement too small
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns