VW Code 16104
16104 Description And Summary : |
---|
When you open hydraulic actuator position sender (g302), electrical malfunction in circuit causes include a bad boost pressure sensor or a vacuum leak in the system secondary air injection pump-c-relay (j704), circuit open circuit . So for next transmission coolant circuit relay, intermittent will delay your vw fault. |
16104 Possible Causes:
16104 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Engine Oil Temperature Sensor Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 16104 Code
- Inspect all the connections injector control pressure sensor, circuit range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns