VW Code 16100
16100 Description And Summary : |
|---|
Accumulated in electronic control units so nox sensor heater sense bank 1, circuit range / performance to change the oil filter and use the recommended engine oil to avoid any problems in the future so gear/ratio monitoring adaptation, limit reached or change angle sensors 2 for butterfly valve drive 2 (g298), signal too largely is the final reason of the code. |
16100 Possible Causes:
16100 vw fault code may be caused by one or more of the following:
- Fuel Composition Sensor Circuit Malfunction
- Reverse Input Circuit
- Fuel Temperature Sensor B Circuit Range/Performance
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 10 Contribution/balance Fault
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 16100 Code
- Inspect all the connections load signal from alternator terminal df, short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns