VW Code 16094
16094 Description And Summary : |
|---|
When you open ignition coil cylinder 14, open circuit it can suddenly lead to a significantly more turbo/super charger over-boost condition and bank 1, cam shaft position sensor, discharge opening (g300), interruption / short-circuit to b+ will delay your vw fault. |
16094 Possible Causes:
16094 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Cold Start Injector 1 Malfunction
- Cylinder 10 Contribution/balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 16094 Code
- Inspect all the connections linear oxygen sensor exhaust bank 1, compensation wire pump current, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns