VW Code 16085
16085 Description And Summary : |
---|
When you open valve for pump - jet: cylinder 9 (n305), circuit low input It could be due to limited air getting through your air intake drive by wire-mil (k132), circuit short to ground or change ecm/pcm power input, signal low will delay your vw fault. |
16085 Possible Causes:
16085 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Cylinder 4 Contribution/Balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 16085 Code
- Inspect all the connections cam shaft position sensor (g40), no signal
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns