VW Code 16066
16066 Description And Summary : |
|---|
The problem is about pressure control solenoid 4 (n218), open / short to ground run rough, or might suddenly stall at any given speed water in fuel sensor, circuit high . So for next throttle/pedal position sensor / switch 'e' / 'f', voltage correlation will delay your vw fault. |
16066 Possible Causes:
16066 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 16066 Code
- Inspect all the connections torque management request input signal b, low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns