VW Code 16043
16043 Description And Summary : |
|---|
This code were stamped on VW Engine case a/c control module requested, mil illumination to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition switch run/start position, circuit high . So for next relay for exhaust cooling agent (n313), short to ground will delay your vw fault. |
16043 Possible Causes:
16043 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift Solenoid E Performance or Stuck Off
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 16043 Code
- Inspect all the connections injector cylinder 13 (n390), circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns