VW Code 16041
16041 Description And Summary : |
---|
Accumulated in electronic control units so ignition switch run/start position, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition coil 'j' primary control, short to plus also relays for pump load air cooling (j536), short-circuit after pluses will delay your vw fault. |
16041 Possible Causes:
16041 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 10 Contribution/balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injector Circuit Malfunction - Cylinders
- Cylinder 4 Contribution/Balance Fault
- Fuel Rail Pressure Sensor Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 16041 Code
- Inspect all the connections injection pump, timing calibration not learned
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns