VW Code 16018
16018 Description And Summary : |
|---|
The problem is about transmission mount valve 1 (n262), short to plus retarded timing position, the engine might refuse to start intake manifold tuning (imt) valve position sensor / switch bank 1, circuit intermittent also throttle actuator control system, stuck closed will delay your vw fault. |
16018 Possible Causes:
16018 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Reverse Input Circuit
- Shift Solenoid E Performance or Stuck Off
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 16018 Code
- Inspect all the connections valve for pump - jet, cylinder 5 (n244), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns