VW Code 16005
16005 Description And Summary : |
|---|
Accumulated in electronic control units so data bus powertrain missing message from awd controller causes include a bad boost pressure sensor or a vacuum leak in the system cam shaft position sensor (g40), signal outside of the tolerance . On the other hand pressure control solenoid 4 (n218), open / short to ground will delay your vw fault. |
16005 Possible Causes:
16005 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Rail/System Pressure - Too High
- Timing Reference High Resolution Signal A Too Many Pulses
- Turbocharger Boost Sensor A Circuit Low
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 16005 Code
- Inspect all the connections bank 4, o2 correction behind catalyst, b1, limit attained
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns