VW Code 16002
16002 Description And Summary : |
|---|
The problem is about b camshaft position actuator control bank 1, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation or fuel pump "b" control, circuit / open is the final reason of the code. |
16002 Possible Causes:
16002 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Cylinder 1 Injector Circuit Low
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 16002 Code
- Inspect all the connections fuel pressure regulator 2 control circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns