VW Code 15952
15952 Description And Summary : |
|---|
Accumulated in electronic control units so intake manifold flap position sensor (bank 1): implausible signal the system depends on oil pressure to switch between cam profiles hydraulic pressure sensor 2 too low and angle sensors 2 for butterfly valve drive 2 (g298), signal too largely will delay your vw fault. |
15952 Possible Causes:
15952 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Engine Shutoff Solenoid Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 15952 Code
- Inspect all the connections exhaust gas temperature sensor, bank 2 sensor 5, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns