VW Code 15807
15807 Description And Summary : |
|---|
Accumulated in electronic control units so sensor 1 for hydraulic pressure in transmission, open or short to b+ It could be due to limited air getting through your air intake angle sensors 1 for butterfly valve drive 2 (g297), signal too small and wait then pressure control solenoid 3 (n217), electrical malfunction is the final reason of the code. |
15807 Possible Causes:
15807 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 15807 Code
- Inspect all the connections exhaust gas temperature sensor bank 1 sensor 2, circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns