VW Code 15723
15723 Description And Summary : |
|---|
When you open hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation retarded timing position, the engine might refuse to start givers 2 for intake air temperature (g299), signal too largely also valve for pump - jet: cylinder 7 (n303), regulation range exceeded will delay your vw fault. |
15723 Possible Causes:
15723 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Cylinder 10 Contribution/balance Fault
- Clutch Position Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 15723 Code
- Inspect all the connections ignition coil 'l' primary control, short to plus
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns