VW Code 15714
15714 Description And Summary : |
|---|
This code were stamped on VW Engine case control module throttle actuator position, performance to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust bank 3, probe 1 tension too largely . On the other hand secondary air injection pump-d-relay (j705), circuit electrical malfunction will delay your vw fault. |
15714 Possible Causes:
15714 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 10 Contribution/balance Fault
- Cold Start Injector 1 Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 15714 Code
- Inspect all the connections ignition coil 'a' secondary circuit, malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns