VW Code 15613
15613 Description And Summary : |
|---|
Accumulated in electronic control units so ignition coil 'c' primary control, circuit low It could be due to limited air getting through your air intake coolant circulation pump relay (j151), short to ground and wait then accelerator pedal position sensor 1 (g79), signal too high is the final reason of the code. |
15613 Possible Causes:
15613 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Injector Circuit Malfunction - Cylinders
- Reverse Input Circuit
- O2 Sensor Heater Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 15613 Code
- Inspect all the connections intake air heater "a", circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns