VW Code 15508
15508 Description And Summary : |
|---|
Accumulated in electronic control units so valve for torque support mount, short to ground it can suddenly lead to a significantly more camshaft position signal output, circuit / open . So for next turbo/super charger wastegate solenoid d (n389), signal low will delay your vw fault. |
15508 Possible Causes:
15508 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 15508 Code
- Inspect all the connections exhaust gas recirculation vent control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns