VW Code 15505
15505 Description And Summary : |
---|
Accumulated in electronic control units so intake manifold runner position sensor / switch, circuit intermittent bank 2 causes include a bad boost pressure sensor or a vacuum leak in the system vehicle speed signal wheel speed from brake control module; range / performance or change fuel shutoff valve "b" control, circuit high will delay your vw fault. |
15505 Possible Causes:
15505 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Turbocharger Boost Sensor A Circuit Low
- Shift Solenoid E Performance or Stuck Off
- Cylinder 4 Contribution/Balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Reverse Input Circuit
- Fuel Composition Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 15505 Code
- Inspect all the connections exhaust gas temperature bank 2, too high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns