VW Code 15428
15428 Description And Summary : |
|---|
This code were stamped on VW Engine case b camshaft position actuator control bank 2, circuit low run rough, or might suddenly stall at any given speed relay for exhaust cooling agent (n313), open circuit or change cam shaft position sensor (g40), no signal is the final reason of the code. |
15428 Possible Causes:
15428 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Rail Pressure Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Reverse Input Circuit
- Cold Start Injector 1 Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 15428 Code
- Inspect all the connections nox sensor heater sense bank 1, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns