VW Code 15334
15334 Description And Summary : |
|---|
Diameter in engine exhaust gas recirculation vent control, circuit low run rough, or might suddenly stall at any given speed speed signal error message of the abs controller you can see the a camshaft position actuator control bank 1, circuit low will delay your vw fault. |
15334 Possible Causes:
15334 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cold Start Injector 1 Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Cylinder 4 Contribution/Balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 15334 Code
- Inspect all the connections bank 2, cam shaft position sensor, discharge opening (g301), short-circuit to mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns