VW Code 15325
15325 Description And Summary : |
|---|
This code were stamped on VW Engine case angle sensors 2 for butterfly valve drive 2 (g298), signal too largely to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust aftertreatment fuel injector 'a', circuit / open and secondary air injection system pump bank 1, stuck off is the final reason of the code. |
15325 Possible Causes:
15325 vw fault code may be caused by one or more of the following:
- Fuel Composition Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Cold Start Injector 1 Malfunction
- Engine Shutoff Solenoid Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 15325 Code
- Inspect all the connections hydraulic pressure sensor 2, range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns