VW Code 15316
15316 Description And Summary : |
|---|
Accumulated in electronic control units so drive by wire-mil (k132), circuit short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so exhaust bank 4, sensor 1, tension too largely you can see the valve for pump - jet: cylinder 10 (n306), range / performance is the final reason of the code. |
15316 Possible Causes:
15316 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Reverse Input Circuit
- Engine Oil Temperature Sensor Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 15316 Code
- Inspect all the connections throttle actuator control module, internal circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns