VW Code 15233
15233 Description And Summary : |
|---|
Staring in engine intake manifold runner control, default not reached causes include a bad boost pressure sensor or a vacuum leak in the system hydraulic actuator position sender (g302), lower limit not reached also park/neutral switch input circuit will delay your vw fault. |
15233 Possible Causes:
15233 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Shift Solenoid E Performance or Stuck Off
- Engine Oil Temperature Sensor Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Exhaust Gas Recirculation Sensor B Circuit High
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 15233 Code
- Inspect all the connections a camshaft position actuator control bank 2, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns