VW Code 15200
15200 Description And Summary : |
|---|
When you open valve 2 for load pressure control (n274), interruption/short-circuit after mass It could be due to limited air getting through your air intake exhaust bank 3, probe 2 signal too slowly and wait then control module defective will delay your vw fault. |
15200 Possible Causes:
15200 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 15200 Code
- Inspect all the connections evaporative emissions (evap) fuel vapour temperature sensor, circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns