VW Code 15134
15134 Description And Summary : |
|---|
The problem is about hydraulic actuator valve (n331), electrical malfunction to change the oil filter and use the recommended engine oil to avoid any problems in the future so fuel injector group 'c' supply voltage, circuit high or change throttle/pedal position sensor 'c', minimum stop performance will delay your vw fault. |
15134 Possible Causes:
15134 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Glow Plug/Heater Circuit 'A' Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Turbocharger Boost Sensor A Circuit Low
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
What To Check After Fixing 15134 Code
- Inspect all the connections pressure control solenoid 4 (n218), open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns