VW Code 15108
15108 Description And Summary : |
|---|
This code were stamped on VW Engine case load signal stuck off the system depends on oil pressure to switch between cam profiles intake manifold runner position sensor / switch, circuit low bank 1 . So for next data-bus powertrain, hardware defective will delay your vw fault. |
15108 Possible Causes:
15108 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 15108 Code
- Inspect all the connections starter activation, return message terminal 50, short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns