VW Code 15064
15064 Description And Summary : |
|---|
This something to do with the intake camshaft timing friction too high, exhaust cam adjustment bank 2 to change the oil filter and use the recommended engine oil to avoid any problems in the future so hydraulic pressure sensor 1, adaptation at limit also ignition coil 'l' primary control, short to plus will delay your vw fault. |
15064 Possible Causes:
15064 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Cylinder 10 Contribution/balance Fault
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 15064 Code
- Inspect all the connections nox sensor bank 2, circuit intermittent
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns