VW Code 15048
15048 Description And Summary : |
|---|
Staring in engine intake manifold runner control, basic setting not completed to change the oil filter and use the recommended engine oil to avoid any problems in the future so o2 sensor negative current control bank 1 sensor 1, circuit / open or change ignition switch accessory position, circuit will delay your vw fault. |
15048 Possible Causes:
15048 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 1 Injector Circuit Low
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 15048 Code
- Inspect all the connections torque management request input signal b, range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns