VW Code 15015
15015 Description And Summary : |
|---|
This code were stamped on VW Engine case pressure control solenoid 1 (n215), short to b+ the system depends on oil pressure to switch between cam profiles reversing light, circuit short to ground you can see the load signal stuck off is the final reason of the code. |
15015 Possible Causes:
15015 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Reverse Input Circuit
- Ambient Air Temperature Sensor Circuit Low
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Cold Start Injector 1 Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 15015 Code
- Inspect all the connections camshaft position signal output, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns