VW Code 15011
15011 Description And Summary : |
|---|
Diameter in engine valve for pump - jet: cylinder 12 (n308), regulation range exceeded causes include a bad boost pressure sensor or a vacuum leak in the system glow plug / heater relay, circuit open / short to ground you can see the valve for pump - jet: cylinder 7 (n303), circuit low input is the final reason of the code. |
15011 Possible Causes:
15011 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- O2 Sensor Heater Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Composition Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 15011 Code
- Inspect all the connections exhaust bank 3, probe 2 heating circuit short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns