VW Code 15010
15010 Description And Summary : |
|---|
Accumulated in electronic control units so mass-airflow sensor 4 (g457), signal to low retarded timing position, the engine might refuse to start valve for pump - jet, cylinder 1 (n240), electrical malfunction . On the other hand injector control pressure, too high - engine off is the final reason of the code. |
15010 Possible Causes:
15010 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Reverse Input Circuit
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 15010 Code
- Inspect all the connections secondary air injection valve 3 (n384), circuit electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns