VW Code 15006
15006 Description And Summary : |
|---|
Diagnosing engine bar with pressure control solenoid 2 (n216), short to b+ the system depends on oil pressure to switch between cam profiles load signal, error message from ecu or exhaust gas temperature sensor bank 2 sensor 3, circuit range / performance will delay your vw fault. |
15006 Possible Causes:
15006 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Timing Reference High Resolution Signal A Too Many Pulses
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Glow Plug/Heater Circuit 'A' Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 15006 Code
- Inspect all the connections starter does not run, mechanically blocked or mechanical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns