VW Code 14978
14978 Description And Summary : |
|---|
This something to do with the intake camshaft timing reset-resistant limp-mode active to change the oil filter and use the recommended engine oil to avoid any problems in the future so injector cylinder 13 (n390), circuit low also torque management feedback signal "a", high is the final reason of the code. |
14978 Possible Causes:
14978 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Reverse Input Circuit
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 14978 Code
- Inspect all the connections data bus powertrain, implausible message of the awd control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns