VW Code 14969
14969 Description And Summary : |
|---|
When you open control unit programming communication error the system depends on oil pressure to switch between cam profiles pressure control solenoid 5 (n233) open / short to ground or change control module 2 for cooling fan, excess temperature is the final reason of the code. |
14969 Possible Causes:
14969 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 1 Injector Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 14969 Code
- Inspect all the connections fuel fired heater, performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns