VW Code 14954
14954 Description And Summary : |
---|
Diameter in engine intake manifold runner control: open stop outside of valid range It could be due to limited air getting through your air intake starter interlock, circuit open and wait then friction too high, intake cam adjustment bank 1 will delay your vw fault. |
14954 Possible Causes:
14954 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Fuel Temperature Sensor B Circuit Range/Performance
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 14954 Code
- Inspect all the connections direct ozone reduction catalyst, efficiency below threshold
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns